Confidential & Proprietary|© ROKIT Healthcare Inc. 2019. All Rights Reserved
Dr. INVIVO 4D User Guide
Preparing to Print with the Hot-Melt Pneumatic Dispenser
1. Make sure the hot-melt dispenser module is already mounted inside Dr. INVIVO with the electricity cable connected.
2. Assemble the hot-melt pneumatic dispenser with the air tube, barrel, adapter, and the precision nozzle tip.
3. Use a nozzle size that is appropriate for the target resolution of the print.
4. Fill the dispenser barrel with materials of interest. Please do not exceed 1/3 of the capacity of the barrel.
5. Place the dispenser into the dispenser module and connect the air tube to the appropriate air inlet located on the left wall of Dr. INVIVO.
6. Heat the barrel using the air dispenser controller and let the material melt. This can take up to 30 minutes.
7. On the LCD display, select [Settings] > [Option] > Dispenser Type (BIO Invivo) > [ON].
8. Return to the [NewCreator K] > [Materials] > [Dispenser 2(L)] > Select a distance between [1S] and [5S]
9. Select [LOAD] to verify that the materials is discharged normally.
1. Filling of the material should not exceed 1/3 of the capacity of the barrel. Otherwise the material may stick to the adapter and interfere
with the air flow.
2. Use only genuine needles or nozzles.
3. Be careful with touching the barrel or tip while it is still hot.
29
INV-CHS-20191210
CAUTION
