Confidential & Proprietary|© ROKIT Healthcare Inc. 2019. All Rights Reserved
Dr. INVIVO 4D User Guide
Preparing to Print with the Syringe Bio-Dispenser
1. Place the hydrogel or cell mixtures to be printed inside a syringe. Be careful not to create bubbles or air layers inside the syringe.
2. Use a nozzle size that is appropriate for the target resolution of the print.
3. Install the syringe onto the dispenser mount and fix the syringe with the bolt on the lower side of the mount..
4. Align the top of the syringe piston wing with the dispenser mount. This can be done by pressing the load and unload buttons.
5. Select [New Creator K APP] > [Filament] > [DISPENSER 1(RIGHT)] on the LCD display.
6. Select between [0.1MM] and [1MM] to adjust dispenser mount’s travel distance at [Distance] window.
7. Select [UNLOAD] or [LOAD] to adjust the dispenser mount height to match the height of the piston.
8. Select [LOAD] 0.1mm at a time to verify that the materials is discharged normally.
1. Filling of the material should not exceed the capacity of the dispenser.
2. Please set [Distance] according to the type and viscosity material. It is recommended to set less than more.
3. Use only genuine needles or nozzles.
28
INV-CHS-20191210
CAUTION
