Trying Out the Instrument
R&S
®
RTE
47
Getting Started 1326.1026.02 ─ 06
7. To return to the original scaling, try the UNDO key in the NAVIGATION area:
a) Press the UNDO key repeatedly until the original scaling is displayed.
b) Press the REDO key to retrace the undone steps. Thus, you can toggle
between the two displays using the undo and redo keys until you perform a
different action.
Tip:
Instead of using the UNDO and REDO keys, you can tap the correspond-
ing icons on the toolbar.
If you use an active single-ended probe, you can measure the DC component of
the signal directly at the probe tip by means of the integrated R&S ProbeMeter:
1. On the "Vertical" menu, tap "Probe Setup".
2. Make sure that the correct channel is selected on the left tab.
3. In the "Additional" section, tap "ProbeMeter".
A result box shows the DC voltage measured by the R&S ProbeMeter.
Changing the Waveform Scaling and Position
