Operating the Instrument
R&S
®
RTE
95
Getting Started 1326.1026.02 ─ 06
Tap the icon and then tap the points that build the mask. Double-tap the last point
to finish mask definition. To create a rectangular mask, draw a rectangle on the
screen. You can move the mask on the screen.
To configure the mask test settings, tap the
icon in the "Mask" result box.
Histogram
The histogram icon on the toolbar shows the last selected histo-
gram type. A short tap on the icon activates the selected histogram.
If you touch the icon and drag your finger down, a menu opens where you can
select another histogram type: horizontal histogram, or vertical histogram.
Tap the icon and then drag a rectangle on the diagram to mark the histogram
area. The histogram for the selected waveform appears.
Touch and hold the histogram area to open the "Histogram" dialog box.
Measurement
Starts an automatic measurement.
You can start up to 8 automatic measurements to run in parallel. The "Automatic
measurment" icon starts the measurements one after the other.
Tap the icon and then tap the diagram with the waveform to be measured. To
define a measurement gate, draw a rectangle on the screen.
To configure the measurement or select a different measurement type, tap the
icon in the "Measurement" result box.
Quick meas
Performs a set of measurements on the selected waveform. You can con-
figure up to 8 measurement types to be included in quick measurement.
Tap the icon and then tap the diagram with the waveform to be measured.
FFT
Transforms a waveform to the frequency spectrum by fast Fourier trans-
form (FFT). The FFT trace is shown in a new diagram.
Tap the icon and then tap diagram with the waveform to be transformed. The FFT
diagram is created from the selected waveform.
To adjust FFT settings, double-tap the FFT diagram.
Toolbar
