Rohde & Schwarz EVSG-B1, User Manual

Page: 113 / 418

Numeric Measurement Modes
R&S
®
EVSG1000
113 User Manual 1178.6227.02 ─ 06
Status flags
The "STIOCPMV" value contains status flags, if applicable:
●
S : Start (started manually)
●
T : Triggered (externally)
●
I : Invalid
●
O : Overload (RF input signal too high)
●
C : Corrected (includes RF input correction factor)
●
P : PPS-synced
●
M : Morse ID available
●
V : Valid signal (ILS LOC/GP and VOR only)
Remote commands for retrieving results:
GETDATADEF
on page 378
GETDATASET
on page 378
4.3.3 Configuring VOR Measurements
The following settings are available for VOR measurements.
Settings for recording, including trigger settings, are described in Chapter 8.2, "Record-
ing Measurement Data" , on page 217.
VOR measurements on LF input
Using the option R&S EVSG1-K7, you can also analyze the AF components of the
VOR signal to determine AF parameters of the carrier.
Furthermore, you can use the LF input to measure signals with a very low intermediate
frequency (<25
kHz). Such signals are provided as output at test points of a transmit-
ter, for example, for tuning purposes.
For details on configuring a VOR measurement on LF input, see
Chapter 4.1.4.5, "LF
Input Configuration" , on page 82.
● General Measurement Configuration .................................................................... 113
● Channel Frequency Configuration (CH FREQ) ..................................................... 115
● Ampt ...................................................................................................................... 116
● Bandwidth (BW) .................................................................................................... 117
● Setting the Measurement Time (MTime) ............................................................... 117
4.3.3.1 General Measurement Configuration
Access : [Config]
VOR Mode (Option R&S EVSG-K2)