Remote Commands
R&S
®
EVSG1000
304
User Manual 1178.6227.02 ─ 06
Parameters:
<State>
READY.
The command was executed successfully.
FA0
This command stops the continuous output that was started with FA1, FA2, FA4, FA5,
STREAM.
Return values:
<State>
READY.
The command was executed successfully.
FA1
This command activates the continuous output of DDM /level measurement results.
The output rate is defined by the current measurement time. Values are separated by a
TAB (ASC 09) DDM [1] RF level [dBm].
The command FA0 stops the output.
Return values:
<State>
READY.
The command was executed successfully.
FA2
This command activates the continuous repetition of a set of values. The output rate is
defined by the current measurement time.
All values are transmitted as integer values, multiplied with a constant factor:
●
DDM [1], Multiplier: 10000
●
RF level [dBm], Multiplier: 10
●
AM-Mod90 [%], Multiplier: 100
●
AM-Mod150 [%], Multiplier: 100
The command FA0 stops the output.
Return values:
<State>
READY.
The command was executed successfully.
FA3
The same output format as
on page 304, but the values are only transmitted when
triggered by another FA3 command. Note that this behavior is different from EVS200,
where the trigger is an arbitrary ASCI character.
ILS Localizer (LOC) and Glidepath (GP) Modes
