Rohde & Schwarz EVSG-B1, User Manual

Page: 241 / 418

Common Instrument Settings
R&S
®
EVSG1000
241 User Manual 1178.6227.02 ─ 06
Remote command:
SETUP:SETGPSBAUDRATE
on page 263
GPS-Delay
Specifies a delay between the received GPS time and the actual time. This value cor-
rects the delay of the transmission of GPS coordinates via a serial interface. Supported
values are from -300
ms to +1000 ms.
Remote command:
SETUP:SETGPSDELAY
on page 264
PPS-Sync
Activates/deactivates synchronization between the GPS time in the stored data sets
and the PPS signal provided by the GPS receiver.
Note: PPS input recommended. It is strongly recommended that you connect the PPS
signal of the GPS receiver to the "PPS In" connector of the R&S EVSG1000. Although
it is possible to store data on the R&S EVSG1000 without the PPS signal connected,
this may lead to an incorrect assignment of the stored data to the actual GPS time.
For details see
Chapter 8.2.1, "GPS Data Synchronization" , on page 218.
"OFF" No PPS synchronization is performed.
"PPS_IN rise" Stored GPS time is synchronized to the rising edge of the incoming
PPS signal.
"PPS_IN fall" Stored GPS time is synchronized to the falling edge of the incoming
PPS signal.
"RS232 rise" Stored GPS time is synchronized to the rising edge of the incoming
GPS signal.
"RS232 fall" Stored GPS time is synchronized to the falling edge of the incoming
GPS signal.
Remote command:
SETUP:PPS_SYNC
on page 264
Interface
Determines the interface used to connect a GPS receiver.
"RS-232" (See Chapter 1.5.2.4, "RS232 GPS" , on page 34)
"USB" Chapter 1.5.1.4, "USB" , on page 29
"USB u-blox" Chapter 1.5.1.4, "USB" , on page 29
Remote command:
SETUP:SETGPSINTERFACE
on page 263
GPS Configuration