Rohde & Schwarz EVSG-B1, User Manual

Page: 97 / 418

Numeric Measurement Modes
R&S
®
EVSG1000
97 User Manual 1178.6227.02 ─ 06
IFSPECT_ATTMODE
on page 356
GBAS:ATTMODE
on page 334
Transducer Correction
Configures the level correction. The specified value is added to the measured power
levels to compensate for an inherent offset by the measurement setup, for example the
antenna.
Remote command:
SETUP:EXTERNALATT_RX1
on page 247
SETUP:EXTERNALATT_RX2
on page 247
4.2.3.3 Setting the Measurement Time (MTime)
Access : [MTime]
Access VNC : [d]
The measurement time determines the interval at which new measurement results are
displayed. Internally, values are captured every 100
ms, that is: 10 per second. (With
the High Measurement Rate option R&S EVSG-K22 installed, the internal capture rate
is 10 ms, that is: 100 per second.) If the defined measurement time is longer, the val-
ues captured internally in that interval are averaged and only the average value is dis-
played.
Note that the measurement time determines the minimum interval for values to be
stored during recording (see
"Time" on page 220).
Enter the time in milliseconds.
Remote command:
MEASTIME
on page 245
4.3 VOR Mode (Option R&S EVSG-K2)
Access : [Mode] > "VOR"
Access VNC : [m] > Down arrow key
If the VOR Mode option (R&S EVSG-K2) is installed, signals from VOR systems can
be analyzed with the R&S EVSG1000.
Remote command:
MODE_VOR
on page 313
VOR Mode (Option R&S EVSG-K2)