Rohde & Schwarz EVSG-B1, User Manual

Page: 119 / 418

Numeric Measurement Modes
R&S
®
EVSG1000
119 User Manual 1178.6227.02 ─ 06
You can display graphical results directly from the COM mode by selecting the softkey
in the "Meas" menu. In this case, the settings for the current measurement are applied
to the graphical results.
To return from the graphical results to the COM mode, select "Return" ([F7]).
For details on the graphical results, see:
●
Chapter 5.1, "RF Spectrum Mode (Option R&S EVSG-K10)" , on page 139
●
Chapter 5.2, "IF Spectrum Mode (Option R&S EVSG-K10)" , on page 144
●
Chapter 5.3, "AF Spectrum Mode (Option R&S EVSG-K11)" , on page 149
●
Chapter 5.4, "AF Time Domain Mode (Option R&S EVSG-K12)" , on page 158
Remote command:
MODE_COM
on page 322
● RF Level and Frequency Display .......................................................................... 119
● IF Spectrum Preview .............................................................................................120
● COM Main View .................................................................................................... 121
● COM Recording View ............................................................................................123
4.4.1.1 RF Level and Frequency Display
The measured RF power and frequency of the input signal are displayed both numeri-
cally and graphically.
Figure 4-23: RF level display
The following results are provided:
●
Numeric power level in dBm ("Lev")
For measurements on two frequencies: individual and sum power levels
●
Measured frequency offset to the nominal frequency in kHz
●
Numeric frequency offset of measured power
●
Numeric power sensor level in dBm (if available; "NRP")
●
Bargraph indicating the power and a color-coded overload state, where:
–
red : overload state, check message
– yellow : power approaching overload state
– green : power in a valid range
●
If applicable: overload messages
COM Mode (Option R&S EVSG-K6)