Data Management
R&S
®
EVSG1000
217
User Manual 1178.6227.02 ─ 06
Factory Preset ← Preset
Access
: [Preset] > "Factory Preset"
VNC access
: [y]
The default configuration is restored, except for the instrument's IP address and host
name. All stored data is deleted!
Remote command:
Save
Stores the current measurement settings in the selected UserPreset under the speci-
fied name, together with the current date and time.
If the selected UserPreset already contained settings before, they are overwritten.
Save to USB
Stores the current measurement settings under the specified name on a connected
USB storage device, together with the current date and time.
The default name is
User_Preset_<no.>.evsgpreset
, where
<no.>
is a consec-
utive number. The file name can be edited. The files are stored to the subdirectory
EVSG1000_PRESETS
.
Recall
Overwrites the current measurement settings by the settings stored in the selected
UserPreset.
Recall from USB
Overwrites the current measurement settings by the settings stored in the selected
UserPreset on a connected USB storage device.
Delete
Deletes the settings and the name assigned to the selected UserPreset.
Rename
Renames the selected UserPreset.
8.2
Recording Measurement Data
During a measurement with the R&S
EVSG1000, the input signal is captured and vari-
ous results are calculated and displayed on the screen (see
on page 48). These results can also be stored in data lists, which can be
exported as
.csv
files for further investigation.
Recording measurement data requires the R&S
EVSG-K21 option.
Data is stored continuously for all measurements that are performed after recording is
started and until it is stopped. The data for each recording session is stored to a file
internally. The file name is defined by the following syntax:
<measmode>_<rx_board>_list<no.>.csv
Recording Measurement Data
