Rohde & Schwarz 1335.8794.02, User Manual, Page: 534 / 861

Remote control commands
R&S
®
RTM3000
534 User Manual 1335.9090.02 ─ 09
Suffix:
<m>
.
1, the suffix is irrelevant.
Parameters:
<State> ON | OFF
ON
Cursor lines keep their relative position to the waveform.
OFF
Cursor lines remain on their position on the display if the scaling
is changed.
*RST:
OFF
CURSor<m>:SPPeak<n>
CURSor<m>:SNPeak<n>
Set the cursor line to the previous / next peak, respectively. The command is only
available for FFT waveforms.
Suffix:
<m>
.
1, the suffix is irrelevant.
<n> 1..2
Selects the cursor line.
Usage: Event
17.7.3.2 Cursor measurement results
To get the measurement values of vertical cursor lines (time, frequency for FFT), use:
●
CURSor<m>:X1Position
on page 532
●
CURSor<m>:X2Position
on page 532
To get the measurement values of horizontal cursor lines (voltage, current, level for
FFT), use:
●
CURSor<m>:Y1Position
on page 533
●
CURSor<m>:Y2Position
on page 533
CURSor<m>:XDELta[:VALue]?
........................................................................................534
CURSor<m>:XDELta:INVerse?
....................................................................................... 535
CURSor<m>:YDELta[:VALue]?
........................................................................................535
CURSor<m>:YDELta:SLOPe?
.........................................................................................535
CURSor<m>:XDELta[:VALue]?
Returns the time difference between two vertical cursor lines (
Δ
t).
Suffix:
<m>
.
1, the suffix is irrelevant.
Measurements