Rohde & Schwarz 1335.8794.02, User Manual, Page: 423 / 861

Remote control commands
R&S
®
RTM3000
423 User Manual 1335.9090.02 ─ 09
17 Remote control commands
This chapter provides the description of all remote commands available for
R&S
RTM3000. The commands are sorted according to the menu structure of the
instrument. A list of commands in alphabetical order ist given in the "List of Com-
mands" at the end of this documentation.
Processing of remote control commands
The response time on remote commands depends on several factors:
●
Number of active channels
●
Number of active measurements
●
Size of the acquisition memory
●
Timebase
●
Trigger frequency
The R&S RTM3000 processes measurement queries in the following way:
●
In stop mode or with slow trigger frequency if no new data since last value calcula-
tion is available, the oscilloscope sends the measured value in the response.
●
Otherwise, if new data since last value calculation is available, the oscilloscope cal-
culates and sends the response.
● Conventions used in command description .......................................................... 423
● Programming examples ........................................................................................ 424
● Common commands .............................................................................................430
● Waveform setup .................................................................................................... 433
● Trigger ...................................................................................................................460
● Waveform analysis ................................................................................................477
● Measurements ...................................................................................................... 514
● Applications ...........................................................................................................536
● Documenting results ............................................................................................. 569
● General instrument setup ......................................................................................591
● Serial bus analysis ................................................................................................ 604
● Power analysis (option R&S RTM-K31) ................................................................ 714
● Mixed signal option (option R&S RTM-B1) ........................................................... 767
● Signal generation (option R&S RTM-B6) .............................................................. 779
● Status reporting .....................................................................................................795
17.1 Conventions used in command description
The following conventions are used in the remote command descriptions:
●
Command usage
If not specified otherwise, commands can be used both for setting and for querying
parameters.
If a command can be used for setting or querying only, or if it initiates an event, the
usage is stated explicitly.
Conventions used in command description