Rohde & Schwarz 1335.8794.02, User Manual, Page: 262 / 861

Serial bus analysis
R&S
®
RTM3000
262 User Manual 1335.9090.02 ─ 09
8. In the "Bus" menu, enable "Decode".
SPI configuration settings
Figure 13-4: SPI (no CS) setup
Figure 13-5: SPI (with CS) setup
Chip Select ..................................................................................................................262
Clock ........................................................................................................................... 263
Slope ........................................................................................................................... 263
MOSI / MISO / Data .................................................................................................... 263
Polarity ........................................................................................................................ 263
Threshold, Find Threshold .......................................................................................... 263
Word Size ....................................................................................................................264
Idle Time ......................................................................................................................264
Chip Select
Selects the input channel of the chip select (CS) line. Only available in the "SPI (with
CS)" setup.
If the MSO option R&S RTM-B1 is installed, you can use logic channels as source.
Remote command:
BUS<b>:SPI:CS:SOURce
on page 607
SPI bus (option R&S RTM-K1)