User Manual – EC II GSM SE
9
5
Introduction
5.1 Foreword
We recommend a carefully reading of this user manual before EC II GSM SE is put into op-
eration, to ensure that the product is used safely and effectively.
EC II GSM SE should only be used in the context for which it is intended. All other form of
usage will be considered as being solely the users own risk. Only qualified persons are per-
mitted to install, program and start-up this product. Start-up is only allowed after the product
has been properly installed. As a consequence Rocom GmbHdisclaims all responsibility for
possible defects, operational disturbance, accidents etc. caused by lack of knowledge or
carelessness from the user. The same principle is valid for all not approved changes to the
product.
EC II GSM SE uses a GSM standard for mobile telephony. The product can consequently not
be used in areas without satisfactory coverage. Since the GSM system is using radio based
technology, disturbances may occur when using other telephone- or radio sets which are not
sufficiently protected against radio waves. The product is following valid security standards for
exposure of electromagnetic radiation.
Rocom GmbH reserves the right to make changes in the product for functional or commercial
reasons. The company is not forced to immediately update reference manuals.
EC II GSM SE cannot be used:
•
On places where there are an explosion hazard.
•
On places where chemical substances are used in a greater extent with particu-
lar regard to safety rules for environments filled with unstable gases or fumes.
5.2 Product description
EC II GSM SE is an alarm equipment for the GSM network with built in duplex speech com-
munication designed for installation in lifts. It complies with requirements according to
EN81:1–2 and EN81:28. The product is CE-marked.
The system consists of two separate units, one central unit which is mounted on top of the
roof of the lift and one speech unit that is mounted inside the lift car and the two units are
joined together with a modular cable.
When someone inside the lift pushes the alarm button, the EC II GSM SE automatically calls
an alarm centre or a predefined alarm receiver and indicates where the alarm comes from. At
the same time voice communications is established and the person in distress can speak di-
rectly to staff at the alarm centre from where help will be dispatched.
EC II GSM SE is normally programmed via a keypad on the rear side of the speech unit but
can also be remote programmed via SMS.
5.2.1 Overview of EC II GSM SE functionality
The central unit of the EC II GSM SE is not visible to the passengers of the lift. It is mounted
on the roof of the lift car. Its function is to initiate, transmit and monitor alarm calls from the
speech unit in the lift to the alarm centre through the GSM network. The central unit contains
a printed circuit board with a GSM module and an emergency power supply with a lead acid
Summary of Contents for EC II GSM SE
Page 1: ...EC II GSM SE User Manual...
