Rockwell Automation Publication 2711T-QS002C-EN-P - March 2019
17
Second Generation MobileView Tethered Operator Terminal
9.
Before you reinstall the junction box to its back plate, consider how you plan to use the
junction box with a second generation MobileView terminal.
10. After you perform any suggestions in
, use a Torx 10 screwdriver and the six screws
to reinstall the junction box to its cover plate.
If
Then
You plan to use a second generation MobileView terminal
that does not have Box ID functionality
You must activate a DIP switch; see
.
You plan to use a second generation MobileView terminal
with Box ID functionality with multiple IP65 junction
boxes
You can assign an address for each junction box specific to
its application; see
BoxID Functionality on page 20
You want to adjust the brightness of the illuminated E-
stop button on a second generation MobileView terminal
You can press an adjustment button for four possible
brightness levels; see
.
Item
PCB
Description
Description
1
S16
11-pin terminal for power, and safety circuits of E-stop push button and enabling switch of the
MobileView 2711T terminal. For more details, see
S16 Terminal Pin Descriptions on page 18
2
ETH3, ETH2
8-pin, RJ45 terminal for Ethernet connectivity to a control system network. Use one terminal for
input and the other terminal for output. For more details,
Ethernet (ETH3, ETH2) Connections on
.
3
S10
6-pin terminal for an application or control system where multiple IP65 junction boxes are used.
This terminal helps identify which IP65 junction box has a second generation MobileView
terminal attached to it. For more details,
S10 Terminal Pin Descriptions on page 19
.
1
2
2
3
