28
Rockwell Automation Publication 2711T-QS002C-EN-P - March 2019
Second Generation MobileView Tethered Operator Terminal
Connect a Second Generation MobileView Terminal to an IP65 Junction Box
To power up or start a second generation MobileView 2711T terminal, insert a 22-pin
connection cable into the MobileView IP65 junction box. A 22-pin connection cable has a black
cable connector.
Connect a Black Bridge Connector to an IP65 Junction Box
An optional black, 22-pin bridge connector (Cat. No. 2711T-22JUMP) is available for the IP65
junction box. It is for situations when the IP65 junction box is powered on but a second
generation MobileView terminal is not connected to the junction box.
In these situations, the black bridge connector is connected so the IP65 junction box is placed in
a bridge active state and its E-stop circuits are bypassed.
The black bridge connector includes a tethered cable so it can be secured with one of the bottom
screws of an IP65 junction box. For more information on the bottom screws, see
Junction Box to Its Back Plate on page 22
Connect to an Ethernet Network
Second generation MobileView 2711T terminals are equipped with an Ethernet interface that
supports TCP/IP protocol at 10/100 Mbps for half/full-duplex communication.
The Ethernet connector on IP65 junction boxes provide a connection to an Ethernet network.
The connector uses an 8-pin, RJ45 modular jack connector.
To connect to an Ethernet network, see
Ethernet (ETH3, ETH2) Connections on page 18
.
IMPORTANT
You can use a 22-pin connection cable with all second generation MobileView terminals, first
generation MobileView terminals 2711T-F10G1N1 and 2711T-T10G1N1, and both IP65
junction boxes.
You cannot use a 22-pin connection cable with first generation MobileView terminals 2711T-
B10K1N1, 2711T-B10M1N1, and 2711T-T10R1N1, or an IP20 junction box.
57 mm (2.25 in)
Red dot on cable connector must align
with red dot on junction box.
