18
Rockwell Automation Publication 2711T-QS002C-EN-P - March 2019
Second Generation MobileView Tethered Operator Terminal
S16 Terminal Pin Descriptions
Ethernet (ETH3, ETH2) Connections
Second generation MobileView 2711T terminals are equipped with an Ethernet interface that
supports TCP/IP protocol at 10/100 Mbps for half/full-duplex communication.
The two Ethernet connectors on the IP65 junction box provide connection to an Ethernet
network. Each connector uses an 8-pin, RJ45 modular jack connector. Pinouts are as follows.
ATTENTION:
Under high noise situations, the Ethernet network can have packet loss of <10% at
100 Mbps. By design, Ethernet communication resends packets, so there is no data loss but there
is a possible reduction in communication speed.
Pin No.
PCB
Description
Description
1
N.C.
Not connected
2
ZT2-
Enabling device, circuit 2-
3
ZT1-
Enabling device, circuit 1-
4
ZT2+
Enabling device, circuit 2+
5
ZT1+
Enabling device, circuit 1+
6
ES2
Emergency stop (E-stop), circuit 2
7
ES1
E-stop, circuit 1
8
ES2
E-stop, circuit 2
9
ES1
E-stop, circuit 1
10
–
Ground (GND)
11
+
24V DC power supply
(see
1
8
Pin #
Ethernet Signal
Pin #
Ethernet Signal
1
TD+
5
Not used
2
TD-
6
RD-
3
RD+
7
Not used
4
Not used
8
Not used
