20
Rockwell Automation Publication 2711T-QS002C-EN-P - March 2019
Second Generation MobileView Tethered Operator Terminal
DIP Switch
If a MobileView terminal does not have Box ID functionality, then use this DIP switch to
configure whether or not an illuminated E-stop button is used on the MobileView terminal.
BoxID Functionality
If you have a second generation MobileView terminal with Box ID functionality, then you can
set an address on the IP65 junction box. With an address, only settings specific to that
application are available on the MobileView terminal. Use the two address switches whenever
one MobileView terminal with Box ID functionality is used between multiple IP65 junction
boxes in various locations. With the two address switches, you can set Box IDs from 0 to 255 as
hexadecimal values.
To use Box ID functionality with FactoryTalk® View ME software, access the Rockwell
Automation Knowledgebase link at
https://rockwellautomation.custhelp.com/
AID 1043633.
If
Then
The MobileView terminal to be used has no Box ID
functionality and no illuminated E-stop button (such as
MobileView terminals with gray push buttons, cat. nos.
2711T-F10G1N1 and 2711T-T10G1N1)
All DIP switches must be
deactivated (factory set as
standard)
The MobileView terminal to be used has no Box ID
functionality but has an illuminated E-stop button
Activate DIP switch 8
IMPORTANT
If the MobileView terminal being used has Box ID functionality and an illuminated E-stop
button, then no action is needed. The IP65 junction box automatically detects the
illuminated E-stop button, and all factory set DIP switch settings remain deactivated.
Table 1 - Address Examples
Left Address
Switch
Right Address
Switch
MobileView
Terminal Address
Left Address
Switch
Right Address
Switch
MobileView
Terminal Address
0
0
0
(1)
(1)
Factory set as standard.
A
0
160
0
F
15
A
F
175
1
0
16
F
0
240
1
F
31
F
F
255
