Ricoh DD 5450, Field Service Manual, Page: 228 / 403

５
226
Chapter 5 Scanner Section
1 Scanner Section
(1) Attaching the Rear Wire
● For removable of the scanner unit
● For removal of the rear wire
Adjustment procedure
1. Insert the ball end of the wire into the groove opening the
pulley. Wrap the wire six times in the rear, and four times on
the operation side.
2. Place the wire on the screw side onto the pulley.
3. Place the wire on the rear pulley of Slider B.
4. Pass the screw through the bracket opening, and secure it
in place with two nuts. (Temporarily secure the bracket and
the screw tip with a gap of 10 mm.)
5. Place the wire on the hook side on the pulley.
6. Place the wire on the pulley in front of Slider B.
7. Place the wire on the corner guide.
8. Place the spring on the hook.
9. Adjust the securing position in 4 so that the total spring
length is approx. 40 mm.
→ See page 186
Place on pulley
Secure with nut
Place on pulley
Place on
pulley
Temporarily secure bracket and
screw tip with a gap of at 10 mm
Place on corner guide
Place on spring
Wrap 6 times
Wrap 4 times
Spring length 40mm
Ball
Place on pulley
→ See page 191
1
2
3 5
8
6
4
7
1
REFERENCE: