Ricoh DD 5450, Field Service Manual, Page: 188 / 403

186
４
Chapter 4 Scanner Section
(3) Removing the Scanner Unit
1. Place the scanner unit on the cutouts from the
paper ejection side.
2. Close the scanner unit.
● When closing the scanner unit, the rail holes
align with the frame holes.
3. Slide the scanner unit and tighten the two rails
by the six screws.
4. Install the stopper with the screw.
5. Install the angle with the screw.
6. Close the scanner unit.
Reinstallation
Cutout
Cutout
1. Remove the document cover.
2. Remove the scanner outer covers (front, rear).
3. Remove the control panel.
4. Remove the rear cover.
5. Remove the screw to remove the stopper.
(S tight hexagon head WH rounded end screw
4 x 8)
6. Remove the screw to remove the angle.
(S tight hexagon head WH rounded end screw
4 x 6)
7. Press the scanner switch to slide the scanner
unit.
8. Remove six screws and then remove the
canner
unit by sliding it to the paper ejection side.
(S tight bind head rounded end screw 4 x 8)
● Do not place the scanner unit directly on the
floor.
→See Page 176
→See Page 172
Angle
Stopper
Scanner switch
rail
Screws
Screws
rail
Slide stopper
Screw hole
Screw hole
Screw hole
Screw hole
Stopper
Scanner unit
Screw
hole
2
IMPORTANT
REFERENCE
Screw
hole
Screw
hole