Ricoh B246 SERIES, Manual, Page: 110 / 268

110
110
Bottom Plate Lift
„
The bottom plate lift motor lifts the bottom plate at the following
times:
z
Just after the original set sensor detects an original
z
When some originals have been fed, and the top of the stack needs
lifting
Bottom Plate
Lift Motor
Service manual, section 6.4.4
ˆ
The main points are on the slide.
ˆ
The timing for the bottom plate motor to lift the bottom plate can be changed with
SP 6900. The default is when an original is detected (as shown on the slide).
However, this can be changed to after the Start key is pressed.
ˆ
The bottom plate sensor determines whether the plate needs lifting.
¾
At the start of the job, just after the pick-up roller has dropped onto the stack,
the bottom plate sensor is activated. The plate must be lifted until the sensor
switches off again.
¾
If the sensor switches on again during the job, the motor lifts the plate again.
ˆ
The bottom plate home position sensor tells the motor when to stop when returning
the plate to home position after the job.