Response Biomedical RAMP 200, User Manual

Page: 18 / 94


1 Place RAMP
®
200 components on a stable work surface within reach of an electrical outlet
(and network connection, if available). Access to the back of each module is required to
connect components.
Refer to Figure 2 for connector locations.
2 Remove the dust protection stickers from TM ports.
3
Connect the TM and any optional devices to the CM using the supplied interconnect cable(s).
4 Connect the supplied power cord to the CM. Plug the other end into a wall socket.
NOTE

Up to three TMs can be connected to each CM.

TMs can be stacked vertically or horizontally (one on top of
another).

CM can be placed on top of the TM.
Figure 1: RAMP
®
200 - front view
RAMP
®
200 Control Module
Touchscreen display
Test cartridge ports
RAMP
®
200 Test Module
(a maximum of three TMs
can be connected to the CM)
Lot card
insertion slot
Port LEDs