Operator’s Guide
As a general rule, while in the System Menu you can exit the menu and
save your changes by simply pressing the control panel MENU button
again.
Adjusting Transition and Rate
The Rate Menu is used to adjust transition rates for the TRAN button and
to enable or disable which bus is involved in a transition or cut.
Figure 32. Rate/Tran Menu
1.
Press the MENU button to bring up the System Menu.
2.
Press RATE to display the RATE/TRAN Menu.
3.
Use the BUS ADJ control to select a bus for rate adjustments. The
selected bus is shown in reverse video. The GANG soft button can
be used to select all of the buses.
4.
Use the RATE ADJ control to set the rate value for the selected bus.
The rate can be adjusted from 0 – 999 video frames.
5.
The TRAN line shows which buses are enabled or disabled for
transition or cuts. The R keypad buttons are used to control which
buses are enabled or disabled as shown:
Figure 33. Bus and Tran Keypad
Note
The L keypad buttons can also be used for enabling and disabling buses.
6.
Use the CLEAR soft button to clear the selected rate(s) to 0.
7.
Press the EXIT soft button to exit the Rate Menu.
System Adjustments and Information Display
Page 33
