Operator’s Guide
Meter View
The Meter View for Gray|328 shows the audio levels for each Program
output, the Solo bus, or Record Return inputs. This is the same audio that
is feeding the Monitor matrix.
To access the Meter View, press the METER soft button in any other
View.
The specific audio signals Viewed—and monitored—are determined by
the state of the PGM OUT and SOLO buttons, as shown in the table
below. The Master Fader position affects the levels seen in the Meter
View. See the Gray|328 Monitor Section Block Diagram on Page 13 for
additional information.
Meter View and
Monitor Outputs
PGM OUT
Button
SOLO
Button
Program outputs
ON
Doesn’t matter
Solo bus
OFF
ON
Record Return inputs
OFF
OFF
Table 1. Meter Table
Figure 27. Meter View
Note
Since the Meter View encompasses the entire LCD screen, the labels for
the soft buttons are not visible. Press the left-most soft button to return to
the Main View, the second left-most button to select the Route View, or
the right-most button to select the Fader Level View.
The meters are peak reading with a 31.25dB/sec decay rate.
Meter View Loudness Monitoring
With Loudness Monitoring enabled the Meter View changes as shown
below.
LCD Views
Page 29
