City Series CST60E
|
99
installation-panels, barriers, faceplates
Inner Black Steel/Enamel Panel Installation (Part #450-907/450-908)
07.22.21
920-401
1
CITY SERIES
1. Identify panels and the order of their installation.
Turn off gas and power to unit and allow to cool to room temperature.
Remove the safety glass and firebox glass at one side only (whichever
is accessible)— see manual for instructions.
2. Install 2 screws loosely on both sides.
4. Slide in the #4 side panels and secure them by thightening the
two screws installed in step 1. Repeat with the #4 side panel on
the opposite side.
6. Drop in the six #1 outer panels, three in front and three in back,
as shown.
Inner Black Steel/Enamel Panel Installation (Part #450-907/450-908)
A
DETAIL A
SCALE 1 : 8
D
DETAIL D
SCALE 1 : 8
E
DETAIL E
E
DETAIL E
5. Clean panels with a cloth. Add the desired media or logs before
installing the inner firebox glass. See this manual for instructions
on how to install the firebox glass.
3
3
3
3
3
3
1
1
1
1
1
1
2
2
4
4
5
5
5
5
#1 x 6
20" (508 mm) x 4-5/16" (110 mm)
#2 x 2
6-3/4" (171 mm) x 2-1/4" (57 mm)
#3 x 6
20" (508 mm) x 11-3/16" (284 mm)
#4 x 2
17-11/16" (449 mm) x 11-3/16" (284 mm)
#5 x 4
17-7/8" (454 mm) x 5" (127 mm)
3. Drop the six #3 inner panels into the firebox, then drop the two #2
side covers, as shown below.
Sheet metal components may have sharp edges. Please handle
with care. The enamel panels require an insulation panel installed
behind them. Failure to do so may result in an elevated operating
temperature and premature failure of the appliance. The Insulation
panels may contain fibre glass or ceramic elements. These may
become airborne or stick to carpets and/or clothing. Handle with
caution.
The use of work gloves and dust masks is recommended when
handling panels and insulation.
BEFORE YOU START
Black Enamel Panels
• Black Enamel panels must be inspected for scratches and
dimples prior to installation. All claims to be recorded at this
time. Claims for damage after installation will not receive
consideration.
• Black Enamel panels will discolor a little during normal operation.
This is normal and should not be considered a defect.
• All hand and finger marks
MUST
be cleaned off with a soft cloth.
Use an ammonia based cleaner (ie. glass cleaner) to remove
any fingerprints before applying heat to the unit.
• Failure to do this will result in burn stains on panels
which you will be unable to remove.
Not protected by
product warranty.
Summary of Contents for City CST60E-LP
Page 125: ...City Series CST60E 125 notes ...
Page 130: ...130 City Series CST60E warranty ...
Page 131: ......
