B-18
Redline Management Suite Administration and Maintenance Guide
Redline Communications Inc. Confidential and Proprietary
WARNING: Clock Offset
Close to End of Scale
The reference clock calibration
procedure initiated by the user has
been completed, but the clock offset is
at the boundaries of the AN100U/UX’s
capabilities
Consider using a more accurate clock source for
reliable base station synchronization.
Upgrade Messages
Another Upgrade operation is
currently running. Skip SNMP
[CLI,WEB] backup
The user has tried to backup the active
image to the alternate while a software
upgrade is in progress. The command
has been ignored.
Information only. There is no action required.
Another Upgrade operation is
currently running. Skip SNMP
[CLI,WEB] restore
The user has tried to apply a
configuration file to either the active or
alternate images while a software
upgrade is in progress. The command
has been ignored.
Information only. There is no action required.
Another Upgrade operation is
currently running. Skip SNMP
[CLI,WEB] synchronization
The user has tried to synchronize the
active and alternate images while a
software upgrade is in progress. The
command has been ignored.
Information only. There is no action required.
Another Upgrade operation is
currently running. Skip SNMP
[CLI, WEB] upgrade
The user has tried to initiate an
upgrade while another upgrade is
already in progress. The command
has been ignored.
Information only. There is no action required.
Another Upgrade operation is
currently running. Skip switch
over
The user has tried to switch software
versions while an upgrade is in
progress. The command has been
ignored.
Information only. There is no action required.
Synchronization of alternate
completed successfully
Software image and configuration
have been applied to the alternate
image, overwriting its previous
contents.
Information only. There is no action required.
Synchronization of
configurations not possible
The synchronization of software and
configuration from the active image to
the alternate has failed.
If you see this message, place the AN100U/UX
into monitoring mode in order to further diagnose
the problem. See “Monitoring Your System” on
page 2-4
Table B-1
AN100U/UX Event Log Messages (continued)
Message
Description
Comment