26
rayteccctv.com
Raytec Global Tel: +44 (0) 1670 520055
Americas Tel: +1 613 270 9990
Manual Setting / Level Indication using RHS Button:
The RHS BUTTON will only have an effect if you have selected a mode using LHS
Button – pressing RHS Button without previously pressing LHS Button will have no
effect on the Illuminator operation – it is used to control the setting for the mode
chosen by LHS Button
When you select a mode using LHS BUTTON, the LHS LED will confirm which mode
you are in and RHS LED will show the current setting / level of that mode for the
Illuminator.
Sequential presses of RHS BUTTON will take you through the available options to
get to the required setting you want within that mode. The Illuminator will stay at this
setting / level providing you do not push the RHS BUTTON again. Once you have
reached the required setting as shown in the following text, EITHER press the LHS
BUTTON to cycle through the modes until LHS LED extinguishes showing that you
are at the end of the mode loop OR you can also wait 2 minutes for the illuminator to
time out and the value shown by RHS LED will be stored into the illuminator memory.
The settings programmed will be retained on power recycling unless a reset has
been performed, in which case the factory defaults will be applied.
