25
rayteccctv.com
Raytec Global Tel: +44 (0) 1670 520055
Americas Tel: +1 613 270 9990
Manual buttons can be accessed by removing the base cover of the illuminator.
The buttons are active in both programming mode and operating mode regardless
of whether a PIN is present or not unless you have previously disabled the manual
buttons.
As soon as manual button mode is entered by pressing the Left Hand Button, the
standard LED indicators will be disabled and will indicate a new set of information,
Standard LED indicators are enabled after exiting manual button modes.
Mode Selection by using LHS Button:
A momentary press of LHS button turn LHS LED solid RED and enters the user into
the Illuminator Settings Modes.
In these modes you can change the following settings:
•
Power Level
•
Photocell sensitivity
•
Indicator LED status (On or Off)
A continuous 4 second press of the LHS button turns LHS LED flashing RED and
enters the user into the Illuminator Security Modes.
In these modes you can change the following Security/Configurations:
•
Illuminator Re-set
•
Disable Remote Control and enter Operating Mode or Enable Remote Control
and enter Programming Mode
•
Manual Button Enable / Disable
NOTE
: Unless detailed as part of the functionality, if an invalid or blocked button
push is attempted, both LEDs will flash Red.
NOTE
: If the status indicator LEDs are disabled and you use the manual buttons
the indicator LEDs will still illuminate accordingly.
