19
rayteccctv.com
Raytec Global Tel: +44 (0) 1670 520055
Americas Tel: +1 613 270 9990
Programming Mode and Operating Mode:
On powering up the illuminator or re-applying power after a power interruption and if
no PIN is present, the unit automatically enters programming mode to allow the user
to adjust set-up and operation. The programming mode automatically times out after
7 Days or until the user actively disables the remote control or the unit times out 30
minutes after any press of the manual buttons on the illuminator.
During Programming Mode and Operating Mode the two LED’s indicate the
following status :
LHS SOLID GREEN:
LHS FLASHING GREEN:
RHS FLASHING AMBER:
RHS SOLID AMBER:
LHS FLASHING RED:
LHS SOLID RED:
All functions of the remote control and buttons are available in Programming Mode.
The only function of the Remote Control available during Operating Mode is LED
Status Indicators Enable/Disable, entering a PIN or disabling manual buttons (if done
at the same time as disabling the remote – see P.8)
If a PIN is present the unit will return to Operating mode after a power interruption.
Factory Default: On initial power-up, Programming Mode, No PIN present.
Power Applied
Remote control IR receiver problem (Max VRC
distance is 8m (26ft)
Indicates unit is in programming mode
(Programming Mode Only)
Indicates that a valid command is being received
from the remote (Programming Mode Only)
Voltage supply problem detected
Illuminator fault detected
