29
rayteccctv.com
Raytec Global Tel: +44 (0) 1670 520055
Americas Tel: +1 613 270 9990
Disabling the Manual Buttons
If the Illuminator is in Operating Mode, once the disable manual buttons command
is executed the buttons will be disabled after 30 minutes. This is to allow the user to
re-enable manual buttons if required.
During this 30 minutes the button response will be the following
•
LHS Button
•
RHS Button
Once the 30 minutes has expired any button push (LHS or RHS) will cause both
indicator LEDs to flash RED and the manual buttons are fully disabled
Disabling the Manual Buttons Using the Remote
The manual buttons can be disabled using the remote.
Once the illuminator is put into Operating mode if the disable remote control Set
Up button (see diagram on Page 20) is pressed again and held for 4 seconds the
manual buttons will be disabled. This is shown by both indicator LEDs flashing RED
after 4 seconds.
(If the Manual Buttons are already disabled, both LEDs will flash RED straight away)
NOTE
: This command can only be used within 5 minutes of the illuminator being put
into Operating Mode using the Remote Control.
•
Illuminator Settings Modes cannot be accessed. A momentary press
of the button will not be recognised and the indicator LEDs will not
change
•
Illuminator Security Modes can be accessed in the normal way by a
continuous 4 second press
•
Pushing this button will cause both indicator LEDS to flash RED
(Unless you are in Security Modes)
