28
rayteccctv.com
Raytec Global Tel: +44 (0) 1670 520055
Americas Tel: +1 613 270 9990
Illuminator Security Modes Detail :
Enter this mode by a long 4 second press of LHS button to turn LHS LED Flashing RED.
Pressing the LHS button again momentarily will turn the LHS LED Flashing GREEN
and pressing a third time momentarily will turn the LHS LED Flashing AMBER. Each
of these colours indicates which setting mode you are in.
A further momentary press of LHS Button will exit from the mode entry, both LEDs will
go blank for 1 second and then return to the standard indication of either operating
mode or programming mode (depending on which mode the illuminator was in
previously before selecting manual controls)
The following modes are available :
Illuminator Reset Mode (LHS LED : Flashing RED)
RHS LED: Solid RED
Keep RHS BUTTON depressed for 4 seconds. RHS LED stays solid RED and then
after 4 seconds both LEDs flash AMBER to show the illuminator has been reset. This
operation is equivalent to the factory reset button on the remote control. It will not
re-set a PIN if one is present.
Remote Control Disable and Enter Operating Mode or Remote Control Enable and
enter Programming Mode (LHS LED : Flashing GREEN)
RHS LED:
Enable Remote: Solid GREEN
Disable Remote: Solid RED
Note : If there is a PIN present and the Illuminator is in Operating mode you cannot
enable the Remote Control and enter Programming Mode
Enable & Disable of Manual Control Buttons (LHS LED : Flashing AMBER)
RHS LED:
Enable Manual Button Control – Solid GREEN
Disable Manual Button Control – Solid RED
Note : If the illuminator is in Operating Mode and the buttons are currently disabled,
you cannot re-enable.
NOTE
: If no buttons are pressed within 2 minutes the illuminator times out and returns
to the previous mode it was in – either Programming Mode or Operating Mode.
