30
rayteccctv.com
Raytec Global Tel: +44 (0) 1670 520055
Americas Tel: +1 613 270 9990
Power Up Functionality
After power is supplied to the unit or if power is interrupted:
If no PIN is present the Illuminator will go into Programming Mode for 7 Days and
then will default to Operating Mode
•
During this time if the remote is used to change settings the illuminator will still
default into Operating Mode after 7 Days from the power up (unless the remote
disable button is used to change the illuminator to Operating Mode)
•
During this time if the manual buttons are used in either Illuminator Settings
Modes or Illuminator Configuration Modes the Illuminator will default into
Operating Mode 30 minutes after the last button press
If a PIN is present the unit will return to Operating mode after a power interruption
RESET Options:
There are Two Re-set options for resetting your VARIO2 illuminator
Settings Re-set:
Pressing and holding the RESET BUTTON on the remote control
(Programming Mode Only) or using the manual buttons to complete a RESET will
restore the factory settings to the illuminator. Note : If a PIN is present it will not be
removed and the illuminator will return to the mode you were in (Programming or
Operating) prior to the re-set command. Both indicator LEDs will flash AMBER when
completed.
Full Re-Set:
The other option to reset your illuminator is available by recycling the
power whilst holding down the two manual buttons. This is a FULL RESET and will
restore factory settings AND remove the PIN if one has been set. Both Indicator LEDs
will flash AMBER when completed.
