Rational SCC Series, Training Manual

Page: 28 / 200

28
CM
Edition 10-2008
Service level: SE -- Basic settings
Adjustment of installation altitude above sea level (since SW C1-06-05) -
500m - 4500m
Press time key, keep it pressed and select installaton altitude in 500m steps by timer
dial. Con rm altitude setting by pressing simultaneously core temperature key once
Adjusting speed of blower motor steam (+/ -10%)
(After blower speed adjustment the original rpm is shown in the temp. display, the
changed rpm is shown in the time display)
Press time key, keep it pressed and adjust displayed rpm with timer dial
SE9 = MIN rpm; SE10 = Start rpm; SE11 = MAX rpm
NOTE: After changing speed of blower motor a waste gas analysis MUST be carried
out in the function test.
Adjusting speed of blower motor hot air top (+/ -10%)
(After blower speed adjustment the original rpm is shown in the temp. display, the
changed rpm is shown in the time display)
Press time key, keep it pressed and adjust displayed rpm with timer dial
SE12 = MIN rpm; SE13 = Start rpm; SE14 = MAX rpm
NOTE: After changing speed of blower motor a waste gas analysis MUST be carried
out in the function test.
Adjusting speed of blower motor hot air bottom (+/ -10%)
(After blower speed adjustment the original rpm is shown in the temp. display, the
changed rpm is shown in the time display)
Press time key, keep it pressed and adjust displayed rpm with timer dial
SE15 = MIN rpm; SE16 = Start rpm; SE17 = MAX rpm
NOTE: After changing speed of blower motor a waste gas analysis MUST be carried
out in the function test.
+
+
+
+