Chapter 5: Using the PDU
33
2. Examine your PXE device and the connected equipment to remove
or resolve the cause that results in the overload or short circuit.
This
step is required, or you cannot proceed with the next step.
3. Press the ON button until it is completely down.
Resetting the Handle-Type Circuit Breaker
Your handle-type circuit breakers may look slightly different from the
images shown in this section, but the reset procedure remains the same.
To reset the handle-type breakers:
1. Lift the hinged cover over the breaker.
2. Check if the colorful rectangle or triangle below the operating handle
is GREEN, indicating that the breaker has tripped.
3. Examine your PXE device and the connected equipment to remove
or resolve the cause that results in the overload or short circuit.
This
step is required, or you cannot proceed with the next step.
Summary of Contents for PXE
Page 16: ......
Page 339: ...Appendix A Specifications 323 RS 485 Pin signal definition al 4 5 6 D bi direction al Data 7 8...
Page 380: ...Index 364 Z Zero U Products 1...
Page 381: ......