Rapid 2005, Installation, Operation & Service Manual

Page: 61 / 162

SECTION 12: I
NLET
H
OOD
51 of 147
Step 12.2.10
For inlet hoods w ith permanent al u min u m mesh filters, contin u e to step 12.2.11.
For inlet hoods w ith birdscreen, no filters, the instr u ctions end here.
For inlet hoods w ith moist u re limiter, contin u e to step 12.2.12.
Step 12.2.11
For inlet hoods w ith permanent al u mim u m mesh filters the instr u ctions end here.
Drip Rail
Attach drip rail to each side u sing fi v e TEK self-tapping scre w s for each drip rail. Ens u re that the drip
rails are positioned abo v e the filter clips ( w here applicable), u sing the pro v ided holes in the side w all
panels. Apply ca u lk to the drip rails before attaching to the side panels.
NOTE: Do u ble sided filter rails or snap fasteners are not req u ired for inlet hood w ith moist u re limiter.
Description Part Number
Drip Rail 13505092
TEK Scre w s 13404
Filter
Load filters into the inlet hood, checking to see that each filter is in the proper orientation by
v erifying that the arro w on the side of the filter points in the direction of air flo w . All of the arro w s
sho u ld be pointing to w ards the air handler w hen installed in the proper orientation. Once filters are
installed, close filter clips installed pre v io u sly ( See Page 50, Step 12.2.8 ) to hold filters in place.
Description Size Part Number
Permanent Al u min u m Mesh Filter
in 20 x 20 x 1
20628
cm 50.8 x 50.8 x 2.5