Rapid 2005, Installation, Operation & Service Manual

Page: 131 / 162

SECTION 19: S
TART
-
UP
P
ROCEDURES
121 of 147
Table 23: Burner Mode by Amplifier Type
19.6 Safety Shut Off Valve Check
After the initial start u p and gas press u re adj u stment,
v erify gas so u ndness of each SSOV (Safety Sh u t Off
Val v e). This check m u st be repeated after the first
100 ho u rs of operation.
19.7 Temperature Control System Calibration
The temperat u re control system components are
factory calibrated to a base resistance so that
component replacement
w ill not u pset the system
calibration. If the temperat u re control system sho u ld
req u ire field calibration, refer to the pro v ided
temperat u re control amplifier prod u ct information
sheet.
Table 24: Maximum Temperature Rise
* Also applies to VAV style at minim u m airflo w .
Amplifier Type Hi g h Fire Mode Low Fire Mode
Series 14
Remo v e w ire #45 from ter-
minal #4 on the amplifier
Remo v e w ire #16 from
terminal #8 on the
amplifier
Series 44
Remo v e w ires #40 and #45
from terminals #2 and #4
on the amplifier
Remo v e w ire #16 from
terminal #9 on the
amplifier
SC11 Signal
Conditioner
Set BMS to max fire or
remo v e inp u t w ires #40 and
#41 from terminals #6 and
#5 and connect a 9VDC
battery to the signal condi-
tioner
Remo v e w ire #16 from
terminal #1 on the
signal
Series 94
Disconnect selector ribbon
cable from the amplifier.
Remo v e w ire #16 from
terminal #2 on the
amplifier
Series MP2
Set system to maxim u m
temperat u re
Remo v e w ire #16 from
terminal #2 on the
amplifer
Model
Natural Gas LPG
°F °C °F °C
2005 90 50 70 38.9
2010 - 2010B
Non-Recirc u lating* 100 55 80 44.5
Recirc u lating 49 27.2 42 23.4
2020 - 2030
Non-Recirc u lating* 100 55 80 44.5
Recirc u lating 73.5 40.8 63 35