Ransomes HIGHWAY 213, Operator Instructions Manual

Page: 39 / 93

38
GB GB
GB GB
GB
Fig.21
Fig.22
ASSEMBL ASSEMBL
ASSEMBL ASSEMBL ASSEMBLY OF CUTTING
Y OF CUTTING
Y OF CUTTING Y OF CUTTING Y OF CUTTING
UNITS UNITS
UNITS UNITS
UNITS T T
T T
TO MA O MA
O MA O MA
O MACHINE CHINE
CHINE CHINE
CHINE
FITTING CUTTING UNIT PIVOT SHAFT AND FITTING CUTTING UNIT PIVOT SHAFT AND FITTING CUTTING UNIT PIVOT SHAFT AND FITTING CUTTING UNIT PIVOT SHAFT AND FITTING CUTTING UNIT PIVOT SHAFT AND
HOUSING TO LIFT ARM (Fig.21)
HOUSING TO LIFT ARM (Fig.21) HOUSING TO LIFT ARM (Fig.21) HOUSING TO LIFT ARM (Fig.21) HOUSING TO LIFT ARM (Fig.21)
Front units
a. Fit pivot shaft to lift arm clamp (do not fully
tighten).
b. Assemble hook plate, washer and pivot housing
to shaft and secure with clamping collar, cap
screw and s.l.washer.
c. Adjust pivot shaft in lift arm clamp to allow it to
rotate with no longitudinal movement.
d. Tighten the four clamping screws and
s.l.washers securing the pivot shaft to the lift
arm.
Centre unit
a. Fit pivot shaft to lift arm clamp (do not fully
tighten).
b. Assemble two spacers, washer and pivot
housing to shaft and secure with clamping collar,
cap screw and s.l.washer.
c. Adjust pivot shaft in lift arm clamp to allow it to
rotate with no longitudinal movement.
d. Tighten the four clamping screws and
s.l.washers securing the pivot shaft to the lift
arm.
FITTING CUTTING UNIT TO PIVOT HOUSING FITTING CUTTING UNIT TO PIVOT HOUSING FITTING CUTTING UNIT TO PIVOT HOUSING FITTING CUTTING UNIT TO PIVOT HOUSING FITTING CUTTING UNIT TO PIVOT HOUSING
All units
a. Position cutting unit under lift arm and pivot
housing.
b. Secure pivot housing to cutting unit top deck
using four screws and s.l.washers.
FITTING HYDRAULIC MOTOR TO CUTTING UNIT FITTING HYDRAULIC MOTOR TO CUTTING UNIT FITTING HYDRAULIC MOTOR TO CUTTING UNIT FITTING HYDRAULIC MOTOR TO CUTTING UNIT FITTING HYDRAULIC MOTOR TO CUTTING UNIT
(Fig.22)
(Fig.22) (Fig.22) (Fig.22) (Fig.22)
a. Ensure the gearbox is filled with Shell Simnia
'O' grease or Shell Retinax 'G' grease.
Approimate quantity 0.1kg (0.22lbs) which
should half fill the gearbox.
b. Position the hydraulic motor fitted with drive
pinion and drive adaptor to the mounting plate on
the unit gearbox.
c. Secure hydraulic motor to gearbox using two
screws and washers and two screws, nuts and
s.l.washers.