R&S FSH
Using the R&S FSH in receiver mode
1145.5973.12 4.65
E-14
To define a user table, proceed as follows:
Press the FREQ key.
Press the CHANNEL TABLE softkey.
Press the SELECT USER TAB softkey.
Press the DEFINE USER TAB softkey.
The R&S FSH opens the submenu for entering the
different parameters of the channel table.
A channel table is defined by the number used for the
first channel and the associated frequency, and by the
number of channels and their frequency spacing.
Select 1
ST
CHANNEL NO... by pressing the ENTER key.
Enter the number of the first channel and confirm the entry with the ENTER key.
Press the DEFINE USER TAB softkey.
Select 1
ST
CHANNEL FREQ... from the menu and confirm with the ENTER key.
Enter the frequency of the first channel and terminate the entry with the frequency unit.
Press the DEFINE USER TAB softkey.
Select NO OF CHANNELS... from the menu and confirm with the ENTER key.
Enter the number of channels and confirm the entry with the ENTER key.
Press the DEFINE USER TAB softkey.
Select CHANNEL SPACING... from the menu and confirm with the ENTER key.
Enter the channel spacing and terminate the entry with the required unit key.
Setting the reference level
The reference level is set either in the receiver main menu or by using the AMPT key. This level is the
maximum level of the analog bar graph display.
Set the reference level such that the analog bar graph display is within its scale. However, make sure
the reference level is so low that the measurement signal does not disappear in the inherent noise. This
can be checked, for example, by removing the input signal.
Setting the reference level in the main menu of the receiver mode:
Press the MEAS key.
Press the REF LEVEL softkey.
Change the reference level setting with the cursor keys or the rotary knob, or enter a new reference
level via the numeric keypad.
Confirm the entry of the reference level by pressing the ENTER key.
深圳市盛腾仪器仪表有限公司
Tel:0755-83589391
Fax:0755-83539691
Website: www.Sengt.com
