Power measurements on TDMA signals
R&S FSH
1145.5973.12 4.44
E-14
Power readout
The R&S FSH displays the measured power at the bottom of the measurement diagram (Power =
nn.nn dBm). Usually the trace is not obscured. However, if the trace is in this area of the screen, the
power readout can be removed from the screen. Simply press the POWER DISPLAY softkey and select
PWR DISP OFF using the cursor keys or rotary knob.
Setting the trigger
A trigger is usually required to perform power measurements on bursts. In the default setting, the
R&S FSH is configured to use the video trigger at 50 % of the Y scale on the measurement diagram.
Assuming that the burst on which the measurement is to be made crosses the 50 % point of the trigger,
the R&S FSH will trigger on the rising edge of the burst.
Should this not be the case, the trigger level must be adjusted so that the R&S FSH is triggered by the
burst edge. Otherwise no measurement will be performed.
If the DUT has a trigger facility, the external trigger can also be used for the measurement.
Connect the DUT’s trigger output to the
R&S FSH’s trigger input.
Press the SWEEP key.
Press the TRIGGER softkey.
Select the EXTERN menu item (rising or falling
edge).
Confirm your selection with the ENTER key or the
TRIGGER softkey.
Select the appropriate trigger delay to position the
burst in the measurement window.
Press the DELAY... softkey.
Using the rotary knob or the cursor keys, adjust the
trigger delay until the TDMA burst is inside the
vertical lines indicating the measurement range, or
Using the number keys, enter the appropriate
trigger delay and terminate the entry with the
appropriate unit key.
深圳市盛腾仪器仪表有限公司
Tel:0755-83589391
Fax:0755-83539691
Website: www.Sengt.com