RAM Ram Dodge 2010, Owner'S Manual

Page: 474 / 616

7. After the NEUTRAL indicator light turns off, release
the NEUTRAL button.
8. After the NEUTRAL button has been released, the
transfer case will shift to the position identified by the
selector switch.
9. Shift the transmission into PARK.
10. Release the brake pedal.
11. Disconnect vehicle from the tow vehicle.
12. Start the engine.
13. Press and hold the brake pedal.
14. Release the parking brake.
15. Shift the transmission into DRIVE, release the brake
pedal, and check that the vehicle operates normally.
NOTE:
•
Steps 1 through 5 are requirements that must be met
prior to pressing the transfer case NEUTRAL button
and must continue to be met until one second elapses
and the shift has been completed. If any of these
requirements are not met prior to pressing the NEU-
TRAL button, or are no longer met during the one
second time, then all of the mode position indicator
lights will flash continuously until all requirements are
met or until the NEUTRAL button is released.
•
The ignition switch must be in the ON position for a
transfer case shift to take place and for the position
indicator lights to be operable. If the ignition switch is
not in the ON position, the shift will not take place and
no position indicator lights will be on or flashing.
•
The flashing NEUTRAL position indicator light indi-
cates that shift requirements have not been met.
472 STARTING AND OPERATING