RAM Ram Dodge 2010, Owner'S Manual, Page: 133 / 616

ParkSense
威
will remember the last system state (enabled
or disabled) from the last ignition cycle when the ignition
is changed to the RUN/ON position.
ParkSense
威
can be active only when the shift lever is in
REVERSE. If ParkSense
威
is enabled at this shift lever
position, the system will be active until the vehicle speed
is increased to approximately 11 mph (18 km/h) or
above. The system will be active again if the vehicle
speed is decreased to speeds less than approximately
10 mph (16 km/h).
ParkSense
姞
Sensors
The four ParkSense
威
sensors, located in the rear bumper,
monitor the area behind the vehicle that is within the
sensors’ field of view.
The sensors can detect obstacles from approximately
12 in (30 cm) up to 79 in (200 cm) from the rear bumper
in the horizontal direction, depending on the location,
type and orientation of the obstacle.
ParkSense
姞
Warning Display
The ParkSense
威
Warning screen will only be displayed if
Sound and Display is selected from the Customer-
Programmable Features section of the Electronic Vehicle
Information Center (EVIC). Refer to “Electronic Vehicle
Information Center (EVIC)/Personal Settings (Customer-
Programmable Features) (SETUP)” in “Understanding
Your Instrument Panel” for further information.
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 131