6.3. Connectors assembly
The FOD communication unit can be connected to the user network by metallic or fibre Ethernet cable.
The unit is equipped with those connectors:
■ E1+POE – Gigabit metallic Ethernet port. This port is can power the unit with any Power over Eth-
ernet power source working according to IEEE 802.3at standard.
■ E2 – Slot for user exchangeable SFP module. A wide range of optical modules is available. Both
single or dual mode transceivers can be used. The SFP module with metallic RJ45 interface can
be used as well. Please see the Important notice.
The SFP status LED is located just next to the slot.
■ P – DC power connector.
HW button for service purposes.
■ S – USB service connector.
RSS voltage output connectors.
Fig. 6.24: FOD communication unit connectors
Important
Before connecting the FOD communication unit to the supply (to the user network) the FOD
unit must be grounded according to Section 6.4, “Grounding”.
RAy2 Microwave Link – © RACOM s.r.o.
50
Installation
Summary of Contents for Ray2
