The hash computed for address table lookups is used for the
TrunkMask selection. Use this parameter to reach better load
balancing between the ports in the trunk.
hash
Port name
Identification of the internal switch port. The switch ports are connected to an
external port or to an internal device (radio modem, management CPU).
The external port (with RJ45 interface) labeled "E1+POE".
The external port (with SFP interface) labeled "E2".
The internal port to radio modem, i.e. link to the peer unit.
The internal port to management CPU.
Eth1
Eth2
Air
CPU
Enabled
When this parameter is enabled, the port is considered to be a member of a trunk
with the
Trunk Id
defined below.
Trunk Id
This parameter defines which trunk the port is to be associated with. All ports
that are members of the same trunk must be assigned the same Trunk ID.
Balancing
Trunk Mask bits.
105
© RACOM s.r.o. – RAy2 Microwave Link
Configuration
Summary of Contents for Ray2
