IQ3 Street Logger Dash Installation Manual
38
EFI Interface Programming
Once connection to your EFI system is done, you will need to activate and select your ECU within
the IQ3 Street Dash Settings. This can be done by either using the pushbuttons to get into Setup
Mode 1 on the dash OR connecting a PC to activate through the software. Once the ECU is
selected, the Car Configuration File in your PC will need to be updated and the end user will need
to select what channels are to be displayed on your IQ3 Street Dash. To perform this, follow the
steps below;
1.
Connect the supplied USB programming cable between your PC’s USB port and the
USB port located on the rear of the IQ3 Street Dash
2.
Open the DataLink software and select File from the main menu area located
across the upper area of the screen
3.
Select Open Car Configuration from the pull down menu.
4.
A Select Configuration dialog window will open. A list of folders containing
Configuration files will appear on the left side, while the actual Configuration files
appear on the right side. Select IQ3 in the left window and select
IQ3_Street_Config in the right window.
5.
Click Edit on the menu bar and select Read V-NET Config.
6.
A dialog box (shown right) may appear asking if you wish to
make this configuration the default configuration file. If this is
the only Racepak system you will be programming, select the
top option to make it the default. If using this PC to program
more than one Racepak system, select the second box.
7.
A message log will appear and should begin reading your system configuration.
8.
When finished the message log should display DEVICES READ SUCCESSFULLY!