Fig.1
7
.
7
Fig.1
7
.
8
Fig.1
7
.
9
Select Learn Code, by using the Right button while the
Command is highlighted, Fig 17.7.
Point the TV remote control at the Omni2’s Receiver and
press the On/Off button twice, Fig 17.8.
A check denotes a successful learn operation. A cross
denotes an unsuccessful learn operation, please retry,
Fig 17.9.
Note:
The first time an IR Code has been learned, it is necessary to
cycle the power to the Omni2. If other IR Codes are already
learned, then this is not necessary.
17.
4.1 Learning and IR Code - Sequence
Multiple IR Codes can be learned against one Command in
the Omni2 IR Set-Up Menu. This enables multiple IR Codes
to be transmitted through one Command in the Omni2 when
in IR mode.
Examples:
1. The On/Off function for multiple appliances (the TV and
the DVD for example) can be learned against one entry in
the Omni2 menu. The Omni2 will then transmit the Codes for
the learned Command in one burst. In this case turning the
TV and the DVD recorder on or off, effectively
simultaneously.
2. Previously selecting a TV channel required the user to
select the individual channel’s digits from a list. This could be
quite cumbersome when trying to select a TV channel with
multiple digits e.g. Channel 143. Now the individual Codes
for “1”, ”4” and “3” can be learned against one Command in
the Omni2 IR Set Up Menu. When this Command is selected
in IR Mode, the IR Codes are transmitted effectively
simultaneously.
To create a sequence:
- Select the Command to use as the Sequence initiator.
In this example, TV > On/Off.
- Select Learn Code, by using the Right button while the
Command is highlighted.
- Point the TV remote control at the Omni2’s Receiver and
press the On/Off button twice.
- After each successful learn operation a check
momentarily appears on the screen, select Learn Code
again.
- Point the DVD remote control at the Omni2’s Receiver
and press the On/Off button twice.
- After each successful learn operation a check
momentarily appears on the screen, select Learn Code
again.
This time, the On/Off Command will have a Tick and three
Dots beside it, showing a Learned Sequence. As displayed
in Fig 17.10.
If you choose another appliance, after the first code you load,
switch On & Off, then carry on loading the codes for the new
appliance without interrupting the power.
17.4.2 Enabling and Disabling IR Codes (Fig 17.11)
IR Codes can be enabled or disabled in the IR Set-Up Menu.
If a Code is disabled it will not transmit and will not appear in
the User Menu.
To disable an IR Code, select the ‘–’ key on the Display
Section of the Omni2. Disabled IR Codes appear with an ‘X’
against the highlighted Command.
To enable an IR Code, select the ‘+’ key on the Display
Section of the Omni2. An enabled Code appears with a
check against the highlighted Command.
Fig.1
7
.
10
249044 Rev. A
58
R-Net Control System w/Omni2
Summary of Contents for R-net
