PiXtend
Construction manual:
PiXtend V1.3 Full
Kit Assembly
The top side or placement side of the circuit board should be checked again too:
–
Are there connection wires of some components which touch each other
(especially resistors)?
→ Bend the components a bit to remove the contact
–
Are all ICs, electrolyte capacitors, diodes etc. mounted in the right direction?
→ if necessary desolder, unmount, turn, and solder again
If you are pleased with the soldering joints and the position of all components, the battery
can be soldered. The battery has three connection pins and can be mounted only in one
direction. The result shows Figure 74.
www.pixtend.de
Copyright by Qube Solutions UG (limited liability)
67 / 75
Figure 74: Battery mounted
