PiXtend
Construction manual:
PiXtend V1.3 Full
Kit Assembly
Stick the transistors through the holes and bend the connection wires at the bottom side
like it is shown in the following picture.
After soldering one pin of each component it can be adjusted again and if necessary put it
deeper through the board. After that the rest of the connection wires are getting soldered
and cut with the cutter.
The transistors should be aligned and positioned like that:
www.pixtend.de
Copyright by Qube Solutions UG (limited liability)
53 / 75
Figure 56: Bending the connection wires of the transistors
Figure 57: Positioning of the big transistors
