PiXtend
Construction manual:
PiXtend V1.3 Full
Kit Assembly
The result should look like that:
Like all other parts too, the pin headers are getting put in the board from the top side.
Because the headers don't hold from alone it always is getting one piece put in the board,
hold and turned.
That the loose put pin header doesn't fall out something has to be laid under. We use the
bending aid for that.
www.pixtend.de
Copyright by Qube Solutions UG (limited liability)
39 / 75
Figure 35: Needed Jumper blocks
Figure 36: Bending aid as help for soldering the pin headers
