PiXtend
Construction manual:
PiXtend V1.3 Full
Kit Assembly
2.13 Plug connectors and clamping strips
The plug connectors and clamping strips are getting mounted with the same principle as
the pin headers.
To avoid that the connectors fall out while turning the board for soldering something can be
underlay again.
The plug connectors and clamping strips should be plugged as deep as possible always
and lie neat on the circuit board.
If later wires are getting connected here occurring powers can be absorbed best from the
circuit board. If the strips are “hovering” over the board so the soldering points are
burdened, which should be avoided!
www.pixtend.de
Copyright by Qube Solutions UG (limited liability)
60 / 75
Figure 66: Montage of the clamping strips
