PiXtend
Construction manual:
PiXtend V1.3 Full
Kit Assembly
How showed in figure 16 the connection wires have to be bent. On which side doesn't
matter.
As next step the wires get shortened. The length of the wires should be shorter then 15
mm (measured from the end of the body of the resistor). This is important for the next step:
The resistors can be easily put in the proposed position now.
The single resistors can be differentiated with the colour code. If you don't have a
multimeter you can align the colour codes of the resistors with the following pictures.
Easiest the colours can be seen at daylight or under a bright light.
You must be sure that you identified the resistors right before you
start with the assembling and soldering. If a failure is not found until
initial operation it can lead to malfunction or in worst case to
defects!
Which resistor values have to be placed on which position you can see on the placement
plan and the part list from side 7.
www.pixtend.de
Copyright by Qube Solutions UG (limited liability)
32 / 75
Figure 17: Resistors mounted
